Large diameter high pressure rubber tubing
Large diameter high-pressure rubber tubing is essentially large rubber hoses that have characteristic diameters. Most often, steel wires with clips are mounted on the ends of these pipes to fasten them. The structure of these rubber hoses is not simple at all. They are made according to special standards and specifications. The interior large-diameter high-pressure rubber tubing consists of a special rubber layer. After that, the tube is multi-layered wrapped in fabric and then goes the middle rubber layer. The procedure is repeated once more, so again the layer of fabric and finally the outer rubber layer. These pipes can be additionally reinforced with steel wire, thus increasing the strength of the pipe. They are not produced in one standard size, but you can find them in different diameters, all to meet the specific needs of consumers. When you find a large diameter high-pressure rubber tubing diameter that suits you, you can be sure that you have a very high quality and almost indestructible product.
The very structure of these pipes tells us a lot about their characteristics, which are really at an enviable level. They have the advantages of small outer diameter tolerance. High per mille pipes is resistant to oil and chemicals. They tolerate heat very well but also very low temperatures. They have a suction strength of high negative pressure. The minimum burst pressure of this type of hose is three times higher than their working pressure. In addition to a large number of top performances, you will get pipes that have an exceptional service life. Simply put, these are tubes that are resistant to aging.
Large diameter high-pressure rubber tubing, due to its excellent performance and durability, is used in many industries and industries. They are indispensable in factories, where water and other necessary substances are brought or drained with the help of these pipes. They are one of the indispensable elements in construction and construction works, as well as in industrial mines. In agriculture, they are most often used for irrigation and drainage.
Rubber Hose Size Catalog
Compare tube bore, outside diameter and available wall thickness. Confirm material compatibility and operating requirements for the selected hose.
Rubber Hose
Compare Inside Diameter and Outside Diameter in mm. The cross-section drawing identifies the bore and outside diameter; confirm the selected tube material and service requirements.
Fluororubber Hose
Compare Inside Diameter and Outside Diameter in mm. The cross-section drawing identifies the bore and outside diameter; confirm the selected tube material and service requirements.
Colourful rubber high pressure hose
Compare Inside Diameter and Outside Diameter in mm, together with the listed Thickness and Colour. The cross-section drawing identifies the bore and outside diameter; confirm the selected tube material and service requirements.
Need a different size? Share your drawing, mating dimensions and intended use to discuss a suitable part.
Discuss Your RequirementsProduct specifications
- Product form
- Hollow elastomer tubing for a fitted line or sleeve
- Application focus
- Cable sleeving, industrial fluid lines, irrigation lines and drainage connections. Size the part against the selected assembly.
- Dimensions to confirm
- Inside diameter, outside diameter, wall thickness and cut length. Match these to cable sleeving.
- Large-section support
- Check the hose weight, support spacing and installation bend radius; define connection support as well as nominal diameter.
- Size selection
- Choose the drawing or chart row by its functional dimensions and units; verify mating-part tolerances before ordering.
- Pressure duty
- Define working pressure, surge pressure and the complete hose-and-fitting test conditions.
- Contact conditions
- Lubricating oil and water: define concentration, temperature and contact time, then check compatibility with the chosen compound.
- Exposure to evaluate
- Oil splash. Validate the selected material under the combined conditions.
- Line layout
- Check bend radius, unsupported spans and clearance at both connections.
Need a quote or a custom part?
Send your requirements, drawings or samples to discuss standard and custom silicone rubber parts.
Email us[email protected]